Manualshelf

User's Manual

ManualsBrands3Si Security Systems ManualsElectronicsATM SECURITY SYSTEM
41424344454647484950
5.0 Remove Screws
Remove, and retain, the three securing screws, B, Figure 5.
Figure 5
B
6.0 Prepare Bracket for Installation
Remove the four nuts and remove the CSU plastic cover. See Figure 6.
Locate J3 (Firing circuit) and J4 (Power). Remove the red shunts and replace,
bridging the two posts on each connector. Replace the plastic cover and
securing nuts. Make certain that the two-wire electrical cable between the
CSU electronics and the Ink Block is connected.
J4
J3
SW9
Figure 6
Page F5
Octopus ATM Defense System
Installation and Operation Guide