User's Manual

Figure 7
9.0 Install Bracket
Install the bracket assembly into the cassette with the bracket seated firmly on
the bottom and positioned as far to the front of the cassette as possible (Figure
7). Replace the four screws to secure the bracket and external plastic guide
rails.
Figure 8
10.0 Seal Lid Holes
Cover the three holes on the cassette lid with opaque tape (electrical tape) to
shield the CSU light sensor when the lid is closed (Figure 8).
11.0 Check Fit
Close and open the lid several times to make sure that there is no mechanical
interference.
12.0 Test Electronics
Test the CSU electronics by depressing and releasing SW9 (Figure 6). One
beep indicates that the CSU is fully functional. Two beeps indicates a failure
and requires troubleshooting. Recheck cable connections and shunt
connections (Section 8.0)
Page G6
Octopus ATM Defense System
Installation and Operation Guide