User's Manual

9.0 Install Bracket Mounting Pads
Remove the release backing from the Bracket Mounting Plates and mount the
plates with the holes centered over the dots created in Section 8.0. See Figure
7.
Figure 7
12.0 Secure Bracket Assembly
10.0 Prepare Bracket for Installation
Prepare the bracket and ink delivery system by removing the four nuts and the
CSU plastic cover. Locate J3 (Firing circuit) and J4 (Power). Remove the red
shunts and replace, bridging the two posts on each connector (Figure 6).
Replace the plastic cover and securing nuts. Make certain that the two-wire
electrical cable between the CSU electronics and the Ink Block is connected
(Figure 8).
J4
J3
SW9
Figure 8
Octopus ATM Defense System
Installation and Operation Guide
Page H6