User's Manual

Octopus ATM Defense System
Installation and Operation Guide
Page 5 of 25
Packing List:
The Octopus

ATM defense installation package for a typical two cassette ATM contains a Monitor and Control
Unit (MCU), two Cassette Staining Units (CSU), and a sensor array cable assembly for interface of the MCU to
the ATM. Figure 1 below is a representative picture.
** Note: Units arrive with ink delivery system disconnected, and power off. Opening of both the MCU and CSU
enclosures is required to power the units and connect the ink staining system to the electronics assembly.
Two CSUs are shown installed on their respective bracket assemblies. Below the CSUs are the RJ45 sensor array
cable and the system battery packs. To the right of the CSU brackets are the vacuum form CSU covers which have
been removed for clarity. Below the vacuum form covers is the MCU unit with cover removed.
The battery packs are attached using velcro tape attached to PCB and battery pack.