User's Manual

13.0 Install Spray Bar Assembly (Figure 10)
Clean the area under the aluminum currency guides with alcohol. Remove the
release paper from the spray bar bracket.
Connect the ink delivery tube (on the spray bar) to the quick-connect elbow
fitting on the ink block. Make sure that the tube is fully inserted and locked
into the fitting. Rotate the spray bar bracket legs around the aluminum
currency guides and position the spray bar on the bottom of the cassette and
firmly push down to seat. Note: make sure that the spray bar clears the
currency by 1 –2 mm.
Clean
with
alcohol
Ink Delivery Tube
Spray Bar
Figure 10
13.0 Check Fit
Close and open the lid several times to make sure that there
is no mechanical interference.
12.0 Test Electronics
Test the CSU electronics by depressing and releasing SW9 (Figure 8). One
beep indicates that the CSU is fully functional. Two beeps indicates a failure
and requires troubleshooting. Recheck cable connections and shunt
connections (Section 10.0)
Octopus ATM Defense System
Installation and Operation Guide
Page H8