Manualshelf

User's Manual

ManualsBrands3Si Security Systems ManualsElectronicsATM SECURITY SYSTEM
61626364656667686970
Remove the bracket, remove the release paper from the securing pad and
install with the hole centered over the marked dot on the cassette wall (Figure
7).
Figure 7
6.0 Prepare Bracket for Installation
Prepare the bracket and ink delivery system by removing the four nuts and the
CSU plastic cover. Locate J3 (Firing circuit) and J4 (Power). Remove the red
shunts and replace, bridging the two posts on each connector (Figure 8).
Replace the plastic cover and securing nuts. Make certain that the two-wire
electrical cable between the CSU electronics and the Ink Block is connected.
Figure 8
J4
J3
SW9
Page I6Octopus ATM Defense System
Installation and Operation Guide