Hardware Guide
Table Of Contents
- Introduction
- 2. Overview
- 3. GE865 Mechanical Dimensions
- 4. GE865 module connections
- 5. Hardware Commands
- 6. Power Supply
- 7. Antenna
- 8. Logic level specifications
- 9. Serial Ports
- 10. Audio Section Overview
- 11. General Purpose I/O
- 11.1. GPIO Logic levels
- 11.2. Using a GPIO Pad as INPUT
- 11.3. Using a GPIO Pad as OUTPUT
- 11.4. Using the RF Transmission Control GPIO4
- 11.5. Using the RFTXMON Output GPIO5
- 11.6. Using the Alarm Output GPIO6
- 11.7. Using the Buzzer Output GPIO7
- 11.8. Indication of network service availability
- 11.9. RTC Bypass out
- 11.10. External SIM Holder Implementation
- 12. DAC and ADC section
- 13. Mounting the GE865 on your Board
- 14. Packing system
- 15. Conformity Assessment Issues
- 17. Document History
GE865 Hardware User Guide
1vv0300799 Rev.15– 2012-04-23
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 23 of 77
In the following flow chart is detailed the proper restart procedure:
NOTE:
In order to avoid a back powering effect it is recommended to avoid having any HIGH logic
level signal applied to the digital pins of the GE865 when the module is powered off or during
an ON/OFF transition.
Modem Reset Proc.
Reset# = LOW
Delay 200ms
Reset# = HIGH
PWRMON = ON
Delay 1s
Modem ON Proc.
N
Y
Start AT CMD.
Delay 1s