Hardware Guide
Table Of Contents
- Introduction
- 2. Overview
- 3. GE865 Mechanical Dimensions
- 4. GE865 module connections
- 5. Hardware Commands
- 6. Power Supply
- 7. Antenna
- 8. Logic level specifications
- 9. Serial Ports
- 10. Audio Section Overview
- 11. General Purpose I/O
- 11.1. GPIO Logic levels
- 11.2. Using a GPIO Pad as INPUT
- 11.3. Using a GPIO Pad as OUTPUT
- 11.4. Using the RF Transmission Control GPIO4
- 11.5. Using the RFTXMON Output GPIO5
- 11.6. Using the Alarm Output GPIO6
- 11.7. Using the Buzzer Output GPIO7
- 11.8. Indication of network service availability
- 11.9. RTC Bypass out
- 11.10. External SIM Holder Implementation
- 12. DAC and ADC section
- 13. Mounting the GE865 on your Board
- 14. Packing system
- 15. Conformity Assessment Issues
- 17. Document History
GE865 Hardware User Guide
1vv0300799 Rev.15– 2012-04-23
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 47 of 77
An example of level translation circuitry of this kind is:
The example is
done with a SIPEX SP3282EB RS232 Transceiver that could accept supply voltages lower than
3V DC.
NOTE:
In this case Vin has to be set with a value compatible with the logic levels of the module. (Max
2.9V DC). In this configuration the SP3282EB will adhere to EIA/TIA-562 voltage levels
instead of RS232 (-5 ~ +5V).