Hardware Guide
Table Of Contents
- Introduction
- 2. Overview
- 3. GE865 Mechanical Dimensions
- 4. GE865 module connections
- 5. Hardware Commands
- 6. Power Supply
- 7. Antenna
- 8. Logic level specifications
- 9. Serial Ports
- 10. Audio Section Overview
- 11. General Purpose I/O
- 11.1. GPIO Logic levels
- 11.2. Using a GPIO Pad as INPUT
- 11.3. Using a GPIO Pad as OUTPUT
- 11.4. Using the RF Transmission Control GPIO4
- 11.5. Using the RFTXMON Output GPIO5
- 11.6. Using the Alarm Output GPIO6
- 11.7. Using the Buzzer Output GPIO7
- 11.8. Indication of network service availability
- 11.9. RTC Bypass out
- 11.10. External SIM Holder Implementation
- 12. DAC and ADC section
- 13. Mounting the GE865 on your Board
- 14. Packing system
- 15. Conformity Assessment Issues
- 17. Document History
GE865 Hardware User Guide
1vv0300799 Rev.15– 2012-04-23
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 74 of 77
15. Conformity Assessment Issues
The Telit GE865 Module has been assessed in order to satisfy the essential requirements of the
R&TTE Directive 1999/05/EC (Radio Equipment & Telecommunications Terminal
Equipments) to demonstrate the conformity against the harmonised standards with the final
involvement of a Notified Body.
If the module is installed in conformance to the Telit installation manuals, no further evaluation
under Article 3.2 of the R&TTE Directive and do not require further involvement of a R&TTE
Directive Notified Body for the final product.
In all other cases, or if the manufacturer of the final product is in doubt, then the equipment
integrating the radio module must be assessed against Article 3.2 of the R&TTE Directive.
In all cases the assessment of the final product must be made against the Essential requirements
of the R&TTE Directive Articles 3.1(a) and (b), Safety and EMC respectively, and any relevant
Article 3.3 requirements.
This Hardware User Guide contain all the information you may need for developing a product
meeting the R&TTE Directive.
Furthermore the GE865 Module module is FCC Approved as module to be installed in other
devices. This device is to be used only for fixed and mobile applications. If the final product
after integration is intended for portable use, a new application and FCC is required.
The GE865 Module is conforming to the following US Directives:
• Use of RF Spectrum. Standards: FCC 47 Part 24 (GSM 1900)
• EMC (Electromagnetic Compatibility). Standards: FCC47 Part 15
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
To meet the FCC's RF exposure rules and regulations:
• The system antenna(s) used for this transmitter must be installed to provide a separation distance
of at least 20 cm from all the persons and must not be co-located or operating in conjunction
with any other antenna or transmitter.
• The system antenna(s) used for this module must not exceed 1.4dBi (850MHz) and 3.0dBi
(1900MHz) for mobile and fixed or mobile operating configurations.