User Manual

Octopus Installation & User Manual
5
Enabled State – LED Green
The Enabled state is applicable only to an Octopus system operating in the Door-Bolt
mode. When both the door and door dead-bolt have been properly opened, the iButton
LED will turn green indicating that the system is enabled but not armed. The system
proceeds to the armed state (see below) when both the door and door dead-bolt are
properly closed.
Arming Delay (or “Pre-Armed”) State – LED Flash Red / Green
Prior to arming there is a delay called the ―Arming Delay‖. The delay is 5 seconds for
Auto-Arm mode, and 5 minutes if the optional Door-Bolt mode. During the arming delay
the system is not monitoring for an attack, and the iButton LED will flash red then green.
Armed State – LED Red
When in the Armed state, the system is monitoring for attack. The iButton LED will be
red. If the ATM is attacked, the system will activate (see below) and stain the ATM
currency.
Activation State – LED Rapid Flash Red
When the system has detected an attack on the ATM, the MCU commands the CSU to
activate and stain the currency. The iButton LED will rapidly flash red. The activation
state can be reset by using an iButton Key (see iButton description below). In addition,
the following optional features will activate (refer to Optional Features, Appendix F):
Optional Bank Alarm Interface: If configured for external bank alarm interface,
the MCU’s normally closed contacts will open, thereby activating the external
bank alarm.
Optional Internal Siren: If the Internal Siren is installed, the siren will sound on
activation. After 15 minutes, the siren will cease.
Optional Note-Stop: If the Note-Stop module is installed, the ATM will be
disabled and will not dispense bills.
Daily Operating Procedures
Regardless of the protection mode being used (Auto-Arm or Door-Bolt), normal daily
operating procedures for the ATM itself are not affected. The Octopus system will
automatically arm and disarm as the machine is serviced and money cassettes are
replenished.
If physical repair of the ATM is required, maintenance personnel should be made aware
that an anti-theft protection system is installed. Prior to beginning the ATM repair, the
Octopus system should be disabled via the iButton Key (see procedures below).
System Maintenance
No special maintenance is required for the Octopus system for a period of two years.