Owner manual

Visit our webpage for more info at: http://www.3xlogic.com
3xLOGIC Inc. Doc# 13111317 Page 5 of 10
3.5 Confirm Advanced Options for your VISIX IP camera
Click the Show Advanced Options button(circled above) in the top right corner to
extend the mains screen to include advanced options.
From here, you can select and/or edit:
Resolution
Bitrate
Frames Per Second (FPS)
I-Frame Intervals
Use Audio
Resolution – This will allow you to see the resolutions (minimum and maximum) this
particular camera will support. Select from the list provided the resolution best suited
for your application.
Bitrate – This enables you to tailor the amount of bandwidth the camera will use to
communicate back to the VIGIL Server system. The higher the bitrate, the more
bandwidth that will be used. Typically the higher the resolution, the higher the bitrate
necessary to support that resolution. The exception to this rule would be if you have
your FPS set low (e.g. 2 FPS) then you might use a more conservative bitrate (e.g.
1024K).
Frames Per Second (FPS) – As the title implies, this allows you to see/ set the
Frames Per Second you want your camera to record at.
I-Frame Intervals – I-Frame (Index Frames) Intervals can be set lower than the
Frames Per Second allowing you to conserve memory when saving your video files.
While this setting is application-specific, typically we set this interval to 1 Second.
Use Audio – Click on this checkbox if you want to enable Audio capture (camera-
dependent).