Datasheet

ManualsBrands4D SYSTEMS ManualsDev KitsPCB design board

Uncontrolled Copy when printed or downloaded.

Please refer to the 4D Systems website for the latest Revision of this document

4D Arduino Adaptor Shield

Arduino and variant Compatible Shield

4Display-Adaptor-Shield

** Hardware Revision 2.xx **

Document Date: 30

May 2014

Document Revision: 1.3

DATASHEET

Summary of content (8 pages)

PAGE 1
4D Arduino Adaptor Shield DATASHEET Arduino and variant Compatible Shield 4Display-Adaptor-Shield ** Hardware Revision 2.xx ** Document Date: 30th May 2014 Document Revision: 1.3 Uncontrolled Copy when printed or downloaded.
PAGE 2
4D Arduino Adaptor Shield Contents 1. Description ............................................................................................................................. 3 2. Configuration Options............................................................................................................. 4 2.1. Header 1 (H1) ......................................................................................................................................... 4 2.2. Header 2 (H2) ...................
PAGE 3
4D Arduino Adaptor Shield 4D SYSTEMS 4D Arduino Adaptor Shield – Hardware Revision 2.xx 1. Description ** This Datasheet is for the Hardware Revision 2.xx of the 4D Arduino Adaptor Shield, not for the Hardware Revision 1 4D Arduino Adaptor Shield.
PAGE 4
D Arduino Adaptor Shield 4D SYSTEMS 4D Arduino Adaptor Shield – Hardware Revision 2.xx 2. Configuration Options On the 4D Arduino Adaptor, four jumpers (J1, J2, J3 and J4) have been added to provide flexibility to the users Arduino project, to enable I/O to be changed or disabled as required, including the power source for the display. J1 J2 J3 H2 J4 H1 2.1.
PAGE 5
4D Arduino Adaptor Shield 4D SYSTEMS 4D Arduino Adaptor Shield – Hardware Revision 2.xx 2.4. Jumper 1 (J1) J1 enables the Display Reset to be changed from being triggered from the Arduino on GPIO D4 when in the AR position, or from the H2 connector by means of an external source, when in the PR position. If the jumper is connected between the AR pin and the central RES pin, then the display can be reset by setting D4 low in the Arduino logic, and then high again.
PAGE 6
4D SYSTEMS 4D Arduino Adaptor Shield – Hardware Revision 2.xx 3. Schematic Diagram © 2014 4D SYSTEMS Page 6 of 8 www.4dsystems.com.
PAGE 7
4D Arduino Adaptor Shield 4D SYSTEMS 4D Arduino Adaptor Shield – Hardware Revision 2.xx 4. Specifications and Ratings RECOMMENDED OPERATING CONDITIONS Parameter Supply Voltage (VCC) Conditions 5V supply from either the Arduino itself or from the H2 Header from an External source. Operating Temperature Min Typ Max Units 4.5 5.0 5.
PAGE 8
4D Arduino Adaptor Shield 4D SYSTEMS 4D Arduino Adaptor Shield – Hardware Revision 2.xx 5. Legal Notice Proprietary Information The information contained in this document is the property of 4D Systems Pty. Ltd. and may be the subject of patents pending or granted, and must not be copied or disclosed without prior written permission. 4D Systems endeavours to ensure that the information in this document is correct and fairly stated but does not accept liability for any error or omission.