User Manual

WARNING!
DO NOT INSTALL THIS
PRECISION POWER METER
ON A CARBON FIBER
CRANK ARM.
DOING SO WILL VOID THE
WARRANTY.
Important Product Information
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation. This product
does not contain any user-serviceable parts. Repairs, changes or modications of this product, not
expressly approved by the manufacturer will void the user’s authority to operate the equipment
under FCC regulations.
IC Compliance
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Le present appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts
de licence. L’exploitation est autorisée aux deux conditions suivantes: (1) l’appareil ne doit pas
produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
Declaration of Conformity
4iiii Innovations Inc. declares that this product is in compliance with the essential requirements and
other relevant provisions of Directive 1999/5/EC. To view the full Declaration of Conformity, go to
www.4iiii.com/compliance.
Limited Warranty
This product does not contain any user-serviceable parts. For more information, go to www.4iiii.
com/legal-policies.
Head Oce
228 River Avenue
Cochrane, AB
Canada T4C 2C1
+1 403.800.3095
www.4iiii.com
Technical support available from 4iiii by email from 9am-5pm Mountain
Time.
Email: [e-mail]
© Copyright by 4iiii Innovations Inc.
All rights reserved. Text, text excerpts, images and diagrams are all subject
to copyright. No part may be reproduced or copied without written
permission from the publisher.
2
3
What’s in the Box?
Your Precision
TM
power meter comes with the following
items:
• 1 Precision
TM
power meter pod with installed battery
• 1 Precision
TM
installation tool
• 1 Precision
TM
installation band
• 1 Epoxy adhesive pack
• 1 Epoxy adhesive applicator
• 1 Square of sand paper (1.5” x 1.5”)
• 2 Cleaning wipes
• 1 Cable tie
• 1 Extra CR2032 coin cell battery
Installation Tools
In addition to the contents included with your power meter,
you will also need the following:
• Crank removal tool
• Pencil or permanent marker
• Clean piece of printer paper
Warnings
1. Do not remove the protective tape on the metal plate
of the pod until you are ready to apply the epoxy
adhesive – removing the tape prematurely will result
in contamination of the pod and may interfere with
the accuracy and reliability of the power meter
2. Once the protective tape on the metal plate of the
pod has been removed, do not touch the metal plate
or place the metal plate on any surfaces – will result in
contamination of the pod and may interfere with the
accuracy and reliability of the power meter
3. Once the protective tape of the pod has been
removed, do not place the protective tape or any other
material back on the metal plate – only the provided
epoxy adhesive should be placed on the metal plate
4. Do not put any other tape on the metal plate on the
pod or the crank arm, doing so will contaminate the
surfaces and impact the accuracy of the power meter