User Manual

1.2.1 Pod Placement
Locate a at area on the inner face of the crank arm for
installing the Precision
TM
power meter pod. There should
be a minimum of 40 mm or 1 5/8 inches between the pod
location and the pedal spindle.
1.2.3 Clearance Check
With the Precision
TM
pod xed onto the crank arm as shown
in section 1.2.2, slowly and carefully rotate the crank arm 1
full revolution to ensure there is no interference between the
pod and any part of the bicycle frame.
Do not place the pod over uneven surfaces,
decals, stickers, rivets, or screw holes on the
crank arm. Doing so will interfere with the
accuracy of the power meter.
1.2.2 Using Installation Tool and Installation Band
Place and hold the metal plate of the Precision
TM
pod on
the crank arm as shown in section 1.2.1 and secure the pod
on the crank arm using the provided installation tool and
installation band.
Pull the installation band around the crank arm and attach
them to the hooks on the pod.
Slide the installation tool under the band and x the pod in
place with the installation tool.
If the pod interferes with the frame or any
other components on the bicycle, do not
proceed further with the installation. Contact
your retailer for assistance. If your pod was
purchased directly from 4iiii Innovations,
contact 4iiii online at www.4iiii.com/support/
software-and-documentation.
!
!
76
Figure 1.3
Figure 1.4
Figure 1.5
Figure 1.6