User's Manual

FCC ID: ZZNPM300
Model: PML300
FCC Statement:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This device must accept any interference received, including
interference that may cause undesired operation.
The grantee is not responsible for any changes or modications not expressly approved by the party responsible for
compliance. Such modications could void the user’s authority to operate the equipment.
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable
exposure conditions without restriction.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: If any changes or modications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
RF Exposure Warning
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
ISED Certication Number: 9896A-PM300
Model: PML300
ISED Statement:
This device complies with Innovation, Science and Economic Development Canada licence exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device
must accept any interference, including interference that may cause undesired operation of the device. CAN
ICES-3(B)/NMB-3(B)
Le présent appareil est conforme avec ISED Canada applicables aux appareils radio exempts de licence. L’exploitation
est autorisée aux deux conditions suivantes: (1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de
l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement. CAN ICES-3(B)/NMB-3(B)
The device has been evaluated to meet general RF exposure requirements. The device can be used in portable
exposure conditions without restriction.
L’appareil a été évalué pour répondre aux exigences générales d’exposition aux radiofréquences. L’appareil peut être
utilisé en condition d’exposition portable sans restriction
RF Exposure Information
This equipment complies with ISED RSS-102 radiation exposure limits set forth for an uncontrolled environment. This
transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
Cet équipement est conforme avec ISED RSS-102 des limites d’exposition aux rayonnements dénies pour un
environnement non contrôlé. Cet émetteur ne doit pas être colocalisé ou fonctionner en association avec une autre
antenne ou émetteur.
PAGE 12
REGULATORY
COMPLIANCE