User's Manual

Quick Installation Guide

EAP701 Enterprise Access Point ENGLISH

 Click on the Wireless button on the main menu.

 Select the Repeater tab.

 Choose WDS as the Repeater Type.

 Choose the desired RF card and WDS profile:

(a) Enable WDS.

(b) Enter the MAC Address (peer AP) and then Click SAVE.

If you are using another EAP701 as the peer AP, simply repeat the above-mentioned steps to configure

another peer AP(s).



Note:

On each and every configuration page, you may click SAVE to save the changes of your configured

settings, but you must reboot the system for the changes to take effect. After clicking SAVE, the

following message will appear: “Some modifications have been saved and will take effect after

Reboot.”

Congratulations!

Now, 4ipnet EAP701 is installed and configured successfully.

After EAP701's network configuration is completed, please remember to change the IP Address of

your PC Connection Properties back to its original settings in order to ensure that your PC functions

properly in its real network environments.

 It is strongly recommended to back up your configuration settings.

 For further configuration and information, please refer to the User’s Manual.

P/N: V10020141229