User Manual

© 2008 4IPNET, INC.
71
4ipnet
MSG
100
User
’
s
Manual
Ø Remote VPN Status: Check Enable to activate Remote VPN and allow client devices with Windows Vista
enabled to use Local VPN, or Disable to inactivate it.
Ø IP Address Range Assignment: Enter the start IP address to be used, and the system will automatically
assign up to 10 IP address for clients as the system supports up to 10 remote VPN connections.
Ø SIP Configuration: The system supports SIP transparent proxy for SIP traffic from authenticated Remote
VPN clients with Windows Vista enabled to pass through NAT via a fixed WAN interface. When this
function is enabled, remote clients can access SIP services.
Ø Authentication Option: Check the Enable check box to activate the VPN function for the respective Auth
Options. Check the Default radio button to select a default authentication option. For more information on
Auth Option setting, please refer to Section 4.2.1. Authentication.
Ø Applied Policy to Remote Client: Select a Policy, where the remote VPN function will be applied with.
Ø Group Permission Configuration: Click Configure to enter the Group Permission-Remote VPN
interface for further configuration.
o Group Option: The name of the respective Group Options.
o Enabled: Check the Enable check box to activate the respective Group Options; the above figure
shows that Group 1 to 8 are all allowed to use the Remote VPN service.
o Policy: Select a desired Policy from the drop-down list box; the above figure shows that Policy 1-8
are assigned to Group 1-8 respectively for accessing the remote VPN service.
o To Zone Permission Configuration: Click on the hyperlink of Group options in the To Zone
Permission Configuration column for further configuration. Please refer to Section 4.2.3. Group
for more information.