User Manual
Table Of Contents
- 1. Getting started
- 2. Introduction
- 3. Preparation
- 4. About the terminal
- 5. Mounting and installing the terminal
- 6. Connecting to the terminal
- 7. Managing the terminal
- 8. Configuring the terminal
- 9. Configuring the traffic interfaces
- 10. Cross Connections
- Embedded cross connect switch
- The Cross Connections application
- The Cross Connections system requirements
- Installing the Cross Connections application
- Opening the Cross Connections application
- The Cross Connections page
- Setting the terminal's address
- Management and user ethernet capacity
- Setting card types
- Getting cross connection configuration from the terminals
- Creating cross connections
- Sending cross connection configuration to the terminals
- Saving cross connection configurations
- Using existing cross connection configurations
- Printing the cross connection configuration
- Deleting cross connections
- Configuring the traffic cross connections
- Cross connection example
- Symmetrical Connection Wizard
- 11. Protected terminals
- 12. In-service commissioning
- What you will need
- Checking the antenna polarization
- Visually aligning antennas
- Accurately aligning the antennas
- Synchronizing the terminals
- Checking performance
- Checking the receive input level
- Checking the fade margin
- Checking long-term BER
- Bit Error Rate tests
- Additional tests
- Checking the link performance
- Viewing a summary of the link performance
- What you will need
- 13. Maintenance
- 14. Troubleshooting
- 15. Interface connections
- 16. Alarm types and sources
- 17. Country specific settings
- 18. Specifications
- Ethernet interface
- QJET Quad E1 / T1 interface
- Q4EM Quad 4 wire E&M interface
- DFXO Dual foreign exchange office interface
- DFXS Dual foreign exchange subscriber interface
- QV24 Quad V.24 asynchronous data interface
- HSS Single high speed synchronous data interface
- External alarm interfaces
- Auxiliary interfaces
- AC Power supply
- DC Power supply
- Power consumption
- MHSB protection
- Ethernet interface
- 19. Product end of life
- 20. Abbreviations
- 21. Acknowledgments and licensing
- 22. Commissioning Forms
- 23. Index
Configuring the traffic interfaces | 85
3. Select the required Ingress Rate for this port.
The ingress rate (input data rate) limits the rate that traffic is passed into the port. Operators can
protect the terminal’s traffic buffers against flooding by rate-limiting each port.
Ingress Rate
Unlimited Default
128 kbit/s
256 kbit/s
512 kbit/s
1 Mbit/s
2 Mbit/s
4 Mbit/s
8 Mbit/s
4. Select the Priority for all Ethernet data entering this port.
The priority specifies where the priority control information is sourced from.
From Frames
Traffic is prioritized into one of the following traffic types (numbered 0 to 7) by the originating
device or application. Generally, the higher the priority, the higher the priority rating.
However, in the IEEE standard queuing scheme, the ordering of the priority is 1, 2, 0, 3, 4, 5, 6, 7.
In this case 0 has a higher priority than 1 and 2.
If priority control information is present in the Ethernet header, this information is used to priorities
the traffic but if there is no priority control information in the Ethernet header, the IP header is used
to priorities the traffic.
Low, Medium, High, Very High
The priority rating you select is applied to all traffic on the port and is applied to all traffic
irrespective of traffic type and the priority control information in the traffic.
5. Click Apply to apply changes or Reset to restore the previous configuration.