User Guide

Table Of Contents

Note: (1) Before installing or removing the SIM card, please switch off the device;

(2) Should activate the GPRS function of the SIM card;

(3) Should activate the caller ID function; (activate or not according to the

functions you chose.)

(4) If your SIM card required you to input the SIM PIN, please refer to your

mobile phone user manual to turn off the SIM PIN function.

(5) Please ensure that the SIM card is valid.

3.2 Installation

We recommend a hidden installation, and we suggest that you ask a professional

organization designated by the dealer. Please note the following:

1, Hidden installation, pay attention to waterproof;

2, Do not put together with the launch source, such as reversing radar, anti-theft device or

other in-vehicle communication equipment;

3, GSM antenna and GPRS antenna were built-in the device, make sure that the GPS

receiving surface (GPS antenna surface without label) is upward (toward the sky), and there is

no metal shielding on the top.

Recommended installation location:

(1) Inside the decorative frame under the front windshield of the car;

(2) Areas around the front dashboard of the car (non-metallic material surface);

(3) Under the decorative plate of the rear windshield of the car;

(4) Inside the car door or the middle column;

(5) Inside the instrument panel or under the rear seat of the electric bicycle/motorcycle

4、Wiring precautions

5.1 Please select the harness provided by the original factory. The red line is the positive and

the black is the negative pole of the power supply. When installing the negative pole of

the power supply, please choose to ground or connect metal separately. Do not

connect with other ground wires.

5.2 ACC line (orange line) connected to the vehicle's ACC switch; if ACC auto anti-theft

function is required, make sure to connect the ACC line. The device will enter into the

armed state or not according to ACC status. If the ACC line is not connected, the vehicle

will enter into the armed state. If so, a vibration alarm will be triggered if vibration

when vehicle moving.

Proper use of the product: Installation → Switch on → Settings → Register

Installation: When installing, the GPS antenna surface should face the sky. There should be no

electromagnetic wave absorber (such as metal or explosion-proof film).

Switch on: Insert the SIM card with right direction, connect the cable according to the wiring

diagram, and then switch on the device.

please consult the dealer.