720 Health iTech WIFI Module : Specifications : Page 9

WF-R710-RWA1

IEEE 802.11 b/g/n 1T1R UART SoC Module

Sichuan AI-Link Technology Co.,Ltd. page 9 of 10

4. Requirement of FCC KDB 996369 D03 for module certification:

4.1 List of applicable FCC rules rules:

The module complies with FCC Part 15.247,

4.2 Summarize the specific operational use conditions:

The module has been certified for Fix/Mobile applications. The host product operating conditions must be such

that there is a minimum separation distance of 20 cm (or possibly greater than 20 cm) between the antenna

radiating structures and nearby persons. The host manufacturer is obligated to confirm the use conditions of the

host product to ensure that distance specified in the instructions is met. In this case the host product is classified

as either a mobile device or a fixed device for RF exposure purposes. This transmitter must not be co-located or

operating in conjunction with any other antenna or transmitter.

4.3 Limited module procedures:

Not applicable.

4.4 Trace antenna designs:

Not applicable.

4.5 RF exposure considerations:

This equipment complies with FCC’s RF radiation exposure limits set forth for an uncontrolled environment. The antenna(s)

used for this transmitter must be installed and operated to provide a separation distance of at least 20 cm from all persons

and must not be collocated or operating in conjunction with any other antenna or transmitter. Installers must ensure that 20cm

separation distance will be maintained between the device and users.

Note: the OEM product manuals must include a statement in order to alert the users of FCC RF exposure compliance.

4.6 Antennas:

The antenna is permanently attached, can’t be replaced.

4.7 Label and compliance information:

This device complies with part 15 of the FCC rules. Operation is subject to the

following two conditions:

(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications or

changes to this equipment. Such modifications or changes could void the user’s authority to operate the equipment.

Warning: Changes or modifications to this unit not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of

the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential

installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in

accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee

that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

‐Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

‐Consult the dealer or an experienced radio/TV technician for help.

The system integrator must place an exterior label on the outside of the final product housing the

WF-R710-RWA1 Modules. Below is the contents that must be included on this label.

OEM Labeling Requirements: