User's Manual

10 Command-line utility for Eye 61
7signal Ltd, Panuntie 6, FI-00620 HELSINKI, FINLAND, [phone], [e-mail], www.7signal.com
7signal Sapphire Deployment Guide Release 3.1
Examples:
Query status of the Eye software:
# 7config run status
Start the Eye software:
# 7config run start
Stop the Eye software:
# 7config run stop
Restart the Eye software:
# 7config run restart
List installed Eye softwares:
# 7config run list
Reconfigure the Eye:
# 7config run reconfig
10.7 Txp command group
This command group contains commands for showing and setting of TX power related
parameters. Currently supported operations are showing of TX power settings, setting default
TX power, setting gain of an external antenna and setting cable loss of the external antenna.
7config txp [ARG] [VALUE]
'show' command arguments:
default Show default TX power.
ext Show configured gain of external antenna.
cable Show configured cable loss of external antenna.
If no arguments given, all information will be shown.
'set' command arguments:
default Set default TX power.
VALUE = TX power (dBm).
ext Set gain of external antenna.
VALUE = Gain of external antenna (dBi).
cable Set cable loss of external antenna.
VALUE = Cable loss of external antenna cable
(dB).
Examples:
Show all information in TX power configuration:
# 7config txp show