Setup Guide Part 1

Preface i
7signal Solutions, Inc., 526 S. Main Street, Akron, Ohio 44311, USA, 855-763-9526, [e-mail], www.7signal.com
7signal Sapphire Carat User Guide Release 5.0
PREFACE
Document scope
This document is aimed at people that shall manage and configure 7signal Sapphire quality
tests on WLAN networks. The test pattern configuration and 7signal Sapphire system
administration are explained in this document.
This document does not describe how the software is installed and how to handle the
monitoring station. This is found in 7signal Sapphire Deployment Guide. To get guidance on
how to interpret the measurements, please turn to the 7signal Sapphire Analyzer User Guide.
FCC Compliance
Human RF Exposure
This equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20
centimeters between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
The antennas used for this transmitter must be installed to provide a separation distance of at least 20cm
from all persons and must not be located or operating in conjunction with any other antenna or
transmitter.
Part 15
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at their own expense.
Antennas
This device has been designed to operate on internal antennas or with an external patch type antenna
having a maximum gain of 6dBi. Antennas having a gain greater than 6dBi are strictly prohibited for
use with this device. The required antenna impedance is 50 ohms.
Notes to the user
Any unauthorized modification of 7signal products may result in violation of FCC requirements
which would void the user’s authority to operate the equipment.
This device is restricted to indoor-only use in 5180.0 - 5250.0 MHz and 5470.0 - 5725.0 MHz
bands.
 The FCC ID for the 7signal Sapphire Eye IEEE802.11a/b/g Eye Unit is YLF-2010-08-APU2.
 The FCC ID for the 7signal Sapphire Eye, Model 1001 (802.11a/b/g/n), is YLF-EYE-ABGN-APU3
 The FCC ID for the 7signal Sapphire Eye, Model 2001 (802.11a/b/g/n) is YLF-INEY2001.
Industry Canada Compliance
 The Industry Canada ID for 7signal Sapphire Eye, Model 2001 (802.11a/b/g/n) is 11766A-INEY2001
This Class A digital apparatus complies with Canadian ICES-003.