User Guide Part 2

18 7signal solution 79
7signal Solutions, Inc., 526 S. Main Street, Akron, Ohio 44311, USA, 855-763-9526, [e-mail], www.7signal.com
7signal Sapphire Carat User Guide Release 5.0
o Deauthentication: Monitoring station has deauthenticated itself from the
access point
o Disconnect: Monitoring station has disconnected itself from the access point
o Information: Various types of information events
 State: State change
 CTRL-EVENT-*: Internal supplicant events related to e.g. EAP
authentication.
 Source: Source MAC address causing the event. Either the MAC address of the
monitoring station or the access point.
 Target: Destination MAC address causing the event. Either the MAC address of the
monitoring station or the access point.
 Status: Status of the operation. Status or reason code defined by the 802.11 standard.
18.2 Network scan test
The network scan test can also be used as a separate test outside initial deployment. The
deployment is described in the previous section of this guide.
To scan the network, do the following:
1. In the Network topology, select the Eye you want to use for scanning the network
2. Right-click and select “Network Scan”; a test window is displayed in the right pane
3. Select the test duration from the pull-down menu
4. If you want to view information about each antenna, select “Show detailed results”
a. If this checkbox is selected, the results window has a separate line for each
antenna, which might make the window’s content more difficult to read
5. If you want to see compass heading from which the access point was heard, select
“Show antenna headings”
15
6. Select the scan directions – i.e., directional antennas
15
7. Select the channels to scan
8. Select “Scan”
9. The results are displayed in a table
Figure 37: Wireless network scan test
15
Antenna selection is not possible in Soft and Micro Eyes. Only one antenna is available.