User Guide Part 2

18 7signal solution 84
7signal Solutions, Inc., 526 S. Main Street, Akron, Ohio 44311, USA, 855-763-9526, [e-mail], www.7signal.com
7signal Sapphire Carat User Guide Release 5.0
Figure 42: Spectrum analyzer result
18.5 Noise monitor test
18
You can measure the noise levels surrounding the monitoring station.
1. In the Network topology, select the Eye that will run the test
2. Right-click and select “Noise Monitor”
3. Select the scan directions – i.e., directional antennas
19
4. Select the channels to scan
5. Select “Execute”
6. The results are displayed in a table as seen below
7. To view the results in a graphical view, click “Show graph”
18
Might not be available in Soft and Micro Eyes. Noise reporting support depends on features of WLAN
network interface.
19
Only one antenna available in Soft and Micro Eyes