User Guide Part 2

18 7signal solution 90
7signal Solutions, Inc., 526 S. Main Street, Akron, Ohio 44311, USA, 855-763-9526, [e-mail], www.7signal.com
7signal Sapphire Carat User Guide Release 5.0
b. Or an access point through which the test will be run
23
i. Right-click and select ”Manual tests”
ii. From the submenu select either “TCP Upload Test” or “UDP Upload
Test”
2. Select the Sonar against which you want to run the test, or type another IP address
3. Select test type, WLAN or Ethernet
4. Select the Eye’s IP address (DHCP or static)
24
a. If static, enter the (1) local IP address, (2) local net mask, and (3) gateway
5. Set up the test options:
a. Select the amount of data from the pull-down menu
b. (UDP only): Packet size to be used (small = 256, medium = 1024, large = 32768
bytes)
c. (UDP only): Sender (Eye) port. Default 0 means that system will allocate ports
.User-given port overrides this setting. Please observe possible firewall
settings.
d. (UDP only): Receiver (Sonar) port. Default 0 means that system shall allocate
used ports. User-given port overrides this setting. Please observe possible
firewall settings.
e. Specify how many times the test is to be run
f. Select the display format for the results from the pull-down menus
g. Select the traffic classes to use (licensed products only)
6. Select “Execute”. Test progress information can be seen in the “Test progress” area.
The results are displayed in a table as seen below.
You can change how the test results are shown even after the test is executed.
23
Meaningless of Ethernet test is chosen.
24
Only if WLAN test is chosen.