User Guide Part 2

18 7signal solution 92
7signal Solutions, Inc., 526 S. Main Street, Akron, Ohio 44311, USA, 855-763-9526, [e-mail], www.7signal.com
7signal Sapphire Carat User Guide Release 5.0
7. Select “Execute”. Test progress information can be seen in the “Test progress” area.
The results are displayed in a report as seen below.
You can change how the test results are shown even after the test is executed.
Figure 50: Ping test
18.11 Trace route test
This test helps one perform network troubleshooting and identify routing problems or
firewalls that may be blocking access to a host.
1. In the Network topology, select
a. the Eye that will run the test
i. Right-click and select ”Manual tests | Traceroute Test”
ii. Select an access point from the pull-down menu
b. Or an access point through which the test will be run
27
i. Right-click and select ”Manual tests | Traceroute Test”
2. Select the Sonar against which you want to run the test, or type another IP address
3. Select test type, WLAN or Ethernet
4. Select the Eye’s IP address (DHCP or static)
28
a. If static, enter the (1) local IP address, (2) local net mask, and (3) gateway
5. Set up the test options:
a. Minimum TTL: minimum number of devices/hops to try
27
Meaningless if Ethernet test is chosen.
28
Only if WLAN test is chosen.