User Guide Part 2

18 7signal solution 93
7signal Solutions, Inc., 526 S. Main Street, Akron, Ohio 44311, USA, 855-763-9526, [e-mail], www.7signal.com
7signal Sapphire Carat User Guide Release 5.0
b. Maximum TTL: maximum number of devices/hops to try
c. Queries per hop: how many times a device/hop is tried
d. Timeout: how long to wait before giving up on a device/hop
e. Test timeout: how long the test is allowed to be run at maximum (useful if
there is a risk that the destination Sonar is unreachable)
6. Select the traffic classes to use (licensed products only)
7. Select “Execute”. Test progress information can be seen in “Test progress” area
The results are displayed in a report as seen below.
Note: You can change the report type even after the test is executed
Figure 51: Traceroute test
18.12 Access point traffic test
This test listens to radio traffic in the Sapphire Eye’s coverage area and gathers many kinds of
information.
1. In the Network topology, select the Eye that will run the test
2. Right-click and select ”Manual tests | Access Point Traffic Test”
Note: This test is among the active tests since it requires you to select a target access
point
3. Select the target access points from the table
4. Select the listening time (in seconds)
5. Select “Execute”