User Guide Part 2
18 7signal solution 100
7signal Solutions, Inc., 526 S. Main Street, Akron, Ohio 44311, USA, 855-763-9526, info@7signal.com, www.7signal.com
7signal Sapphire Carat User Guide Release 5.0
3. Select IP address
a. Use DHCP of the WLAN network by checking the box
34
i. DHCP result shall affect other test parameters as the actual servers
shall be dictated by the result and the reliability is expected.
b. Use of static IP address configuration
i. enter the (1) local IP address, (2) local net mask, and (3) gateway
ii. Enter primary DNS server
35
iii. Enter secondary DNS server (optional)
iv. Enter tertiary DNS server (optional)
c. Enter 1st network name to be resolved
d. Enter 2nd network name to be resolved (optional)
e. Enter 3rd network name to be resolved (optional)
4. Select “Execute”. Test progress information can be seen in “Test progress” area.
The result-set is three-fold:
1. General results: IP address obtained, attach time, DHCP retrieval time and gateway
address.
2. Status of DNS servers
3. Results of the name resolving.
18.16 SIP Register test
It is possible to run SIP Register test in both unauthorized and authorized mode.
To run the SIP test:
1. In the Network topology, select
a. the Eye that will run the test
i. Right-click and select ”Manual tests | SIP Registration Test”
ii. Select an access point from the pull-down menu
b. Or an access point through which the test will be run
36
i. Right-click and select ”Manual tests | SIP Registration Test”
2. Select the SIP server to register to
a. From the pull-down menu
i. SIP end-point has to be defined as a test end-point to be selectable
b. Arbitrary IP address
i. Enter IP address and the port
3. Select test type, WLAN or Ethernet
4. Select an access point
37
5. Select the Eye’s IP address (DHCP or static)
38
a. If static, enter the (1) local IP address, (2) local net mask, and (3) gateway
6. Enter the SIP protocol specific parameters
a. Name is mandatory
b. If alone, the test is run as un-authorized
7. Select the WLAN traffic category
39
8. Select “Execute”. Test progress information can be seen in “Test progress” area.
34
Only if WLAN test is chosen.
35
Entering DNS servers are mandatory if Ethernet test is chosen.
36
Meaningless if Ethernet test is chosen.
37
Meaningless if Ethernet test is chosen.
38
Only if WLAN test is chosen.
39
Only if WLAN test is chosen.