- 888 Digital, Inc. DVR User Manual

Front panel and rear panel illustration

Front Panel

①

① Green Light To indicate the Stand-by mode ON/OFF (this mode is controlled

by remote control only).

Rear Panel

① ANT IN connect the antenna here.

② LOOP OUT To connect a RF signal from the STB to either the RF Input jack

(antenna) on your VCR or to the antenna input of your TV.

③ HDMI video output used to connect to your HDMI device.

④ PDIF/COAXIAL Digital audio output.

⑤ S-VIDEO Y/C output for a S-VHS or Hi-Fi Video Recorder.

⑥ AUDIOL/R Audio output to connect to your TV.

⑦ YPbPr High definition video output to connect to your TV.

⑧ VIDEO CVBS output to connect to your TV.

⑨ VGA Video output to connect a VGA display monitor.

⑩ RS-232 Serial port for software upgrade.

⑪ POWER Switch ON/OFF.