User's Manual

SN30 2.4G and SF30 2.4G

Instruction Manual

（Image）

Connection

NES/SNES/SFC Classic Edition (wireless connection)

Plug the 2.4G Retro Receiver into your NES / SFC / SNES Classic Edition.

2. Press START on your controller to connect to the Retro Receiver.

LED will

e solid

lue when connection is successful.



Home Menu Access for NES/SNES/SFC Classic Edition

SELECT + DOWN = RESET



If connection is lost o

youwishto

air with a new retro receiver,

ress an

hol

SELECT on the controller fo

3 seconds.

Blue LED will rapidly blink and be solid blue when connection is successful.

Windows/macOS/Android (wired connection)

Connect the controller to your Windows/macOS/Android via the USB cable.

LED will be solid blue when connection is successful.

X-Input: press and hold START+X for 3 seconds, blue LED blinks twice to indicate mode activation.

D-Input: press and hold START+B for 3 seconds, blue LED blinks twice to indicate mode activation.

macOS: press and hold START+A for 3 seconds, blue LED blinks twice to indicate mode activation.



Default mode: D-inpu

Battery

Status LED Indicator

Low battery Power LED in red

Battery charging Power LED in green

Battery fully charged Power LED turns off

·Built-in 180 mAh Li-on with 25 Hours of play time.

·Rechargeable via USB cable with 60 minutes charging time.

Power Saving

·Sleep mode - 15 minutes with no use.

Support

Please visit support.8bitdo.com for further information and additional support.

PAGE 1
SN30 2.4G and SF30 2.4G Instruction Manual （Image） Connection NES/SNES/SFC Classic Edition (wireless connection) 1. Plug the 2.4G Retro Receiver into your NES / SFC / SNES Classic Edition. 2. Press START on your controller to connect to the Retro Receiver. 3. LED will be solid blue when connection is successful.
PAGE 2
FCC STATEMENT : This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.