User Manual

!
 of 5 12
Setup:
Tilt fulcrum back until the lines on top of fulcrum and arm
base line up.
1 Attach the counter weight tube to the front of the C-pan.
2. Insert the lock pin
Place counter weights on tube. Place the weights as needed
(depending on camera weight) to reach a safe operating
balance. Weights can be set at different positions on the
tube to increase or decrease counter balance. It is important
to test the C-Pan arm at its maximum reach with the camera
mounted to set the right weight requirement.
Attach camera to the camera plate. The camera screw
has a 1/4” thread on one side and 3/8” on the other.
Use the camera plate tilt to position the camera lens in the
middle of the two arms
Check the levelling bubble to insure that the C-pan is set
level in all directions.
After every setup of the C-Pan arm: Double check that the arm always stays stable doing all its movements.
Do this by supporting the camera while guiding it through its initial movements into its maximum positions.