User's Manual

Department
9CD 3.0 – User manual
Version 1.00
Internal 6 (7)
Idesco Oy | Teknologiantie 9, FIN-90590 OULU | Tel [phone] | [e-mail] | www.idesco.fi
2.1. Antenna
The used Idesco antenna types are ATH or ATHC. ATH is a rectangular antenna on printed circuit
board. ATHC antenna is round plastic cylinder with a diameter of 13.5mm and length of 30mm. The
length of cable in both antennas can be up to 17cm.
2.2. Host Device
9CD3.0 has power supply regulation. It uses regulated 10VDC – 30VDC voltage supply which is sup-
plied by host device.
2.3. Labelling instructions
The FCC and ISED certification label of a module shall be clearly visible at all times when installed in
the host product; otherwise, the host product must be labelled to display the FCC and ISED certifica-
tion number for the module, preceded by the word "contains" or similar wording expressing the
same meaning, as follows:
Contains FCC-ID: UJR9CD30
Contains IC: 6701A-9CD30
The module and antenna are labelled according to FCC and ISED certification requirements.
2.4. Installation
9CD 3.0 must be professionally installed.
The only permitted antenna types are ATH and ATHC.
Due to the unique market and function targeted by this product, this product needs a trained profes-
sional engineer to configure and integrate this product into the final host configuration.
The product will not be sold via retail or directly to the general public or by mail order. It will be sold
to authorized dealers or installers only.
The intended use of this product is not for consumers and general public.
9CD 3.0 and antenna must be installed correctly. The tag can only be read when it is within the read-
ing distance of the antenna, which is less than a few centimeters depending on tag type.
The product will be installed inside the host system. It will not be possible to replace either 9CD3.0 or
ATH(C) or both later without disassembling the host system first.
The installation requires special knowledge of the host system, its functions and operations.
This product can be installed by licensed professionals.