User Manual

12-5-2. Recalling the upper and lower limit values

(Quick selection mode)

The procedure below describes an easy way to recall the upper and lower limit values to be

used for weighing. When the recalled upper and lower limit values are to be changed, refer

to "12-5-1. Storing the upper and lower limit values".

Note

Refer to "12-5-1. Storing the upper and lower limit values" for the method to store the

upper and lower limit values.

Step 1 Set the "Data memory (data)" parameter to "4".

Step 2 Press the MODE key to enter the upper/lower

limit value recalling mode. The upper limit value

last selected with its comparator number appears.

The display is as shown to the right, with all the

digits blinking.

Step 3 Press the MODE key to select the value. Each

time the MODE key is pressed, the displayed

value changes as follows:

(

........

↔ C03 HI ↔ C03 LO ↔ C04 HI ↔

C04 LO ↔

........

)

Step 4 Press the PRINT key to confirm the selection. The

balance returns to the weighing mode with the

selected upper and lower limit values ready for use.

To cancel the selection, press the CAL key. The

balance returns to the weighing mode.

Note

When no operation is performed in step 4 (after a few seconds of inactivity), the

balance selects the value currently displayed and returns to the weighing mode

automatically.

Comparator

numbe

Upper

limit

Store

Comparison with

no. 04

Lower

limit

Target

Number

Quick selection