Instruction Manual

WEIGHING

Before Weighing

Automatic power-off function.

If the scale left ON and the stable indicator is displayed, an automatic

power-off function turns power off after approximately 5 minutes.

To disable/enable this function, turn the scale on while pressing the

[RE-ZERO] key. Then

poff0 or poff1 will be displayed.

poff0 Function disabled. poff1 Function enabled.

Select the setting by pressing the [RE-ZERO] key which toggles the display

above, and press the [UNITS] key. The scale shows end and returns to the

weighing mode.

Error message

e Overload: remove excess load on the weighing platform.

----- The scale zero is out of zero range or unstable when powered

on. Make sure no load is on the weighing platform or nothing

touches the platform.

lb Low battery: replace the batteries or use the AC adapter.

Calibration may be required before weighing

Read “CALIBRATION” first and if necessary, calibrate your scale for

accurate weighing.

Weighing Procedures

1. Turn on the scale.

Press the [ON/OFF] key to turn on the scale. Then the scale displays all

segments for a few seconds and then

0 will be displayed.

2. Start weighing

If you do not use a container for weighing,

Verify the reading is

0 . If not, press the [RE-ZERO] key to display

0 . Place objects on the weighing platform to weigh. When the reading

becomes stable, the stable indicator is displayed.

If you use a container for weighing,

Place an empty container on the platform. Wait for the stable indicator to

be displayed and press the [RE-ZERO] key. Place the objects to be

weighed in the container. When the reading becomes stable, the stable

indicator is displayed.

Select the weighing unit

Press the [UNITS] key to select weighing unit either “(k)g”, “lb”, “oz” or

“lb-oz”. The scale will power up with the weighing unit that had been used

when turned off last time.