Instruction Manual

HV-G/HW-G Series Page 71
17. Options
17.3.1. Communication Format
Commands consist of an address and the same command as for the RS-232C.
The address of the equipment is inserted in the first part of the command.
Commands return the same command when the communication format is f15 31
and there is no transmitting data.
If the address is 23, the reply is as follows:
Normal response
Response of impossible command
Undefined command response
Bit Format
17.3.2. Command List
The following explanation uses “Format 1 ( f15 3 )" and assumes that the address
is 23.
Data output
The current weighing data is output.
Template Q
Command
Reply
Selection of mode and unit
Selects the mode and unit. This is the same as the MODE key.
Template U
Command
Reply
The scale changes mode and unit.