Blood Pressure Monitor User Manual

E-15
A&D Medical (Toll-Free): 1-888-726-9966
MEASUREMENT WITH SET PRESSURE
The UA-1020 is designed to detect the pulse and to inflate the cuff to a systolic
pressure level automatically. If re-inflation occurs repeatedly, use the following
methods.
During the blood pressure measurement, re-inflation may occur. A fixed pressure
value can be set to avoid re-inflation.
1. At step 6 of the clock adjustment procedure (see page
E-10), press the
SET
button to go to the pressure setting
mode. The current setting blinks.
2. Press the or button to select a pressure value
about 30 mmHg or more above your expected systolic
pressure from the following.
AUTO
: Automatic pressurization (default value)
180
: Pressure value of 180 mmHg (fixed)
210
: Pressure value of 210 mmHg (fixed)
240
: Pressure value of 240 mmHg (fixed)
3. Press the
SET
button to go to the TriCheck setting mode.
Press the
START
button to turn the device off. After three minutes of
non-operation, the device will turn off automatically. The next measurement
will be performed with the new pressure value.
Turn off
TriCheck
setting mode
or
START
Refer to previous page
for measurement
Press and hold the button
At heart level
Release the button
at the desired
systolic pressure
MEASUREMENT WITH DESIRED SYSTOLIC PRESSURE
Use this method when re-inflation occurs repeatedly even if the pressure value is
set to
240
in the procedure above or when the results are not displayed even if
the pressure decreases to 20 mmHg or less.
1. Place the cuff on the arm (preferably the left arm).
2. Press and hold the
START
button until a number
about 30 to 40 mmHg higher than your expected
systolic pressure appears.
3. When the desired number is reached, release the
START
button to start measurement. Continue to
measure your blood pressure as described on the
previous page.
Turn off
TriCheck
setting mode
or
START
Refer to previous page
for measurement
Press and hold the button
At heart level
Release the button
at the desired
systolic pressure