Use and Care Manual

Mounting options

Your first decision with the Micro SE or A’Diva SE is how and where to mount the speakers. The

standard 1/4-20 threaded mount on the back allows the speakers to be used with several different

mounts available from Anthony Gallo Acoustics.

The Micro SE and A’Diva SE give you six mounting options. Except as noted, all of our aftermarket

mounts are available in colors to match your speakers.

1) Rubber ring stand – this ring comes with the speaker, and allows you to place the speaker

atop a table or flat-topped stand.

2) Wall/Ceiling mount – use this to attach the speaker directly to a wall or ceiling. The mount

allows the speaker to swivel in any direction so you can aim it for the best performance.

3) Single-gang box mount – this mount works like the wall/ceiling mount, but attaches directly to

a single-gang electrical junction box. It facilitates very clean mounting with in-wall speaker cables,

and makes it easy for your electrician or home builder to run the cables for you.

4) Table stand – thread this mount into the threaded hole on the back of the speaker, and you

can place it on a table or flat-topped stand. The table stand’s gimbaled design makes it easy to aim

the speaker for best performance.

5) Wallflower floor stand – simply thread your speakers onto these stands and you have an ele-

gant speaker that can stand on its own on the floor.

6) Ceiling ring – this white, paintable ABS ring mount allows in-wall or in-ceiling installation of the

Micro SE or A’Diva SE. When mounted, the speaker is free to pivot so it can be aimed for the best

sound.

TECH TIP: Because these speakers are small, they have limited bass output. The closer you

put them to a wall or ceiling, the more the bass will be reinforced, and the more smoothly

they can blend with a subwoofer.