User Manual

- 29 -
How to Add a New Device Using “New Mice/KBs ID Pairing”
Step 1.
1. Select “10-Link Meeting Technology” from the G10 MeetingMan Task Listing, the main screen
of “10-Link Meeting Management” will pop up as shown on the right. (For better operation, you
may need another mouse to perform ID pairing before the wireless mouse is applicable).
2. Click
button to start adding the new mouse or keyboard.
Step 1
Step 2.
Follow on-screen instructions to perform “ID Pairing” as shown on the right, click “Next” to
continue.
Step 2
Step 3.
1. Press any key to wake up the mouse before “ID pairing” is performed.
2. Locate the power switch (Normally you can find it on the mouse bottom side).
3. Make sure the power switch is in OFF position and then switch it to ON position within 30
seconds. (If power switch is in ON position, switch it to OFF and back to ON position within 30
seconds).
4. After above procedure is completed, the mouse will start to perform pairing procedure with the
receiver; wait for seconds, the next screen will pop up as shown after ID pairing is completed.
Step 3