User manual

Introduction
XAPP794 (v1.3) December 20, 2013 www.xilinx.com 3
Host PC System Requirements
The host PC requirements to operate the camera design and its applications are:
• 32-bit/64-bit host PC with Ethernet port running Windows XP or Windows 7 Professional
32-bit/64-bit, or Ubuntu 10 or later 32-bit/64-bit Linux distribution.
• UART connected terminal (for example, Tera Term 4.69 or HyperTerminal).
• Zip/Unzip software (for example, 7-Zip).
• Web browser such as Internet Explorer (to operate the web-based GUI).
• USB-UART driver from Silicon Labs [Ref 39] (might already be installed). For information
about installing the USB-UART driver, see Zynq-7000 All Programmable SoC: ZC702
Evaluation Kit and Video and Imaging Kit Getting Started Guide [Ref 1].
To build the hardware and software components, the Vivado® 2013.2 design tools are also
required.
Target Hardware Requirements
The target hardware requirements for running the camera design and its applications are:
• Zynq-7000 All Programmable SoC Video and Imaging Kit, including:
• Xilinx XC7Z020 CLG484-1 SoC-based ZC702 evaluation board.
• Avnet FMC-IMAGEON FMC module.
• VITA-2000 camera module (including optics, tripod, and cable).
• HDMI cable.
• SD-MMC flash card.
• 12V power supply.
• HDMI monitor supporting 1080p60 resolution. A DVI monitor can also be used, but an
HDMI female to DVI-D male connector adapter must be obtained (not provided with the
kit). The connector adapter is available at most electronic retailers or through online
sources.
• SD-MMC flash card writer.
For more information on the Zynq-7000 AP SoC Video and Imaging Kit, see:
www.xilinx.com/zvik
For more information on the Zynq-7000 AP SoC ZC702 evaluation board (including hardware
user manual, schematics, and BOM), see:
www.xilinx.com/zc702
For more information on the Avnet FMC-IMAGEON FMC Module with ON Semiconductor
image sensor, see:
w
ww.em.avnet.com/fmc-imageon-v2000c