User manual

Preparing the SD Card Boot Image
XAPP794 (v1.3) December 20, 2013 www.xilinx.com 54
Regenerating the BOOT.BIN File
The BOOT.BIN file can be regenerated using the SDK tool by following these steps:
1. In the SDK tool window, select Xilinx Tools > Create Boot Image (see Figure 61).
2. Click the Browse button under the Basic tab adjacent to the FSBL elf entry.
3. Select the C:\zc702-zvik-camera\binaries\boot_image\fsbl.elf file and click Open.
4. Click the Add button.
5. Select the C:\zc702-zvik-camera\binaries\boot_image\system.bit file and click Open.
6. Click the Add button again.
7. Select the C:\zc702-zvik-camera\binaries\boot_image\u-boot.elf file and click Open.
8. Click the Browse button adjacent to the Output Folder entry.
9. Select the C:\zc702-zvik-camera\binaries\boot_image file directory and click OK.
10. Click the Create Image button.
11. If the “Output file already exists” dialog appears, click OK.
12. Rename the generated file u-boot.bin to BOOT.BIN.
13. Copy the updated BOOT.BIN file to the SD card.
X-Ref Target - Figure 61
Figure 61: Create Zynq Boot Image Dialog
X794_61_111512