Instructions / Assembly

EPS 3D Wall Panels - Installation Instructions

You will need the following to install the panels correctly:

• A box cutter

• A measuring tape

• A level

• A pencil

• A primer

• An adhesive for polystyrene foam (InstantGrab #310 by Akfix or Power Grab by

Loctite)

• An acrylic filler (optional)

• Acrylic or latex paint (optional)

Remove the panels from the packaging and wait for at least 4 (four) hours to allow the

product to adapt to ambient temperature. Before installing the panels, place them on a

flat surface to arrange them in a pattern and to inspect them for mechanical damage

that may have been caused during transport. Once you install the panels on a wall or

ceiling, you will not be entitled to make any warranty claims.

Step 1. Prepare the surface

The panels should be installed on a clean and dry surface free form loose dirt. Before

installation, any holes in the surface (wall or ceiling) should be filled with a patching

compound. If the surface is covered with wood, plastic or varnish, sand the surface matt

with fine grit sandpaper.

Now prime the surface using a commercial primer.

Step 2. Arrange the panels

Before installing the panels, plan how to arrange them on the surface, paying attention

to the direction of the pattern.

A rough drawing of the arrangement is recommended. Use a level and a pencil to mark

the contours of the panels on the surface.

Step 3. Cutting

To cut the panels, use a wallpaper cutter. Measure the right length and cut it off with a

precise movement.

PAGE 1
EPS 3D Wall Panels - Installation Instructions You will need the following to install the panels correctly: • A box cutter • A measuring tape • A level • A pencil • A primer • An adhesive for polystyrene foam (InstantGrab #310 by Akfix or Power Grab by Loctite) • An acrylic filler (optional) • Acrylic or latex paint (optional) Remove the panels from the packaging and wait for at least 4 (four) hours to allow the product to adapt to ambient temperature.
PAGE 2
Step 4. Install the panels on the wall or ceiling Glue the panels directly onto the wall using a multi-purpose adhesive for polystyrene foam. Apply the adhesive evenly onto the surface, either in spots or all along the edge of the panel, about 1 inch from the edge (the reverse side of the panel), and on the contact edges of the panel. Now press the panel gently onto the surface. Use a damp cloth to remove any excess amount of the adhesive.