Instruction manual

b) EXTERNAL TRIGGERING -
Whenever there is an input pulse in the ‘EXT 2’ input it triggers channel #2 (see Section 9).
c) INTERNAL TRIGGERING -
You can internally connect each channel to any number of the other channels (see Section 9).
4. Connect channel #1 internally to channel #2 -
Press keys: ‘CONNECT,1,2,ENTER’ to connected. (see
Section 9).
Each output of channel #1 triggers channel #2.
Notes:
One.You don’t have to worry about the amplitude or polarity of the trigger source.
Two.The instruction itself is very straightforward (i.e. similar to the way you would say it: -
“CONNECT from #1 to #2, ENTER”).
Three.You can add manual pulses by pressing ‘2’.
5. Set the duration of channel #2 to be 15 msec. -
Press key: DURA,2,15,ENTER,3,ENTER’ (see Section 8)
6. Set the delay of channel #2 to be 100 msec. -
Press keys: DELAY,2,100,ENTER,3,ENTER’ (Please check the new delay).
7. Set channel #3 to the train mode.
Press keys: ‘TRAIN,3,ENTER’.
Channel #3 is now in the TRAIN mode and is waiting for a trigger.
8. Trigger it manually by pressing key ‘3’ (see Section 9)
You then obtain the train of pulses.
9. PULSES PER TRAIN
Set the number of pulses per train of channel #3 to be ‘5’.
Press keys : ‘M,3,5,ENTER,0,ENTER’ (see Section 8).
Trigger Channel #3 manually again by pressing ‘3’.