Instruction manual

8. Setting Parameters
To set the time parameters (DURA, DELAY or INTER), first press the selected parameter key and then
the desired time.
Example: To set the duration of channel 6 to be 52 msec (52 x 10
-3
sec, the time is given in seconds).
Press keys: ‘DURA,6’
(the previous duration is displayed. If the duration time has never been set, the sign ‘FFFF FF’ is
displayed).
Press keys: ’52,ENTER,3,ENTER’. (‘3’ for msec)
For your convenience it is recommended to use only exponents of 6 (µsec), 3 (msec) or 0 (sec).
- e.g. 52 msec can be inserted also as 0.052 x 10
0
sec, or 5.2 x 10
-2
sec, or 5200 x 10
-5
sec etc.
Note:
The new parameter becomes operative, the instant you press the last ENTER.
8.1 Using the ‘’ and ‘↓’ Keys
You can increase or decrease each time parameter using the ‘’ and ‘↓’ keys.
Example:
Press keys: ‘DURA,6’.
By holding down the ‘’and ‘↓’ keys, you will change the duration of
channel 6.
Note: the change takes place only when releasing the key.
Press key: ‘CLEAR DISPLAY’ in order to clear the display.
8.2 Setting the ‘M’ Parameter
Example: To set M=80 pulses per train for channel 8 -
Press keys: M,8. The previous M8 is displayed.
Press keys:’80,ENTER,0,ENTER.