Instruction manual

12. Verification Checks
There are many details you can check.
Note: All the checking instructions begin with the word ‘CHECK’.
1. To check the modes of all the channels -
Press keys: CHECK, ENTER’.
The display shows the modes of all the channels that are not turned off and the present paradigm
number.
2. To check the mode and the parameters (DURATION,DELAY,INTERVAL and M) of a specific
channel (e.g. channel 2) -
Press keys: ‘CHECK,2,ENTER
You can check (and change) each parameter individually, as described above (in ‘setting
parameters”, Section 8)
3. Checking the internal connections:
Example 1: To check which inputs are internally connected to the output of channel 4 -
Press keys: ‘CHECK,4,CONNECT,ENTER’.
If channel 4 does not have any output connections this instruction just clears the display.
Example 2: To check which outputs are internally connected to the input of channel 7 -
Press keys: CHECK,CONNECT,7,ENTER’.
Note: the arrow above the display shows the direction of the connections.
Example 3: To check all the internal connections: -
Press keys: ‘CHECK,CONNECT, CONNECT,ENTER’.
(or: ‘CHECK,CONNECT,ENTER’.)