Instruction manual

4. Operation
Master-8 is simple to operate and can be learned in a short time.
Each instruction is carried out only after pressing the ENTER key. As long as the ENTER key has not
been pressed, the instruction can be changed or deleted by giving new instructions (e.g. the Clear-
Display instruction).
If you insert an illegal instruction, an error message appears on the display and the unit does not accept
this instruction.
4.1 Parameters (see Figure 1)
You can set the following parameters for each channel:
• DURA (duration) - defines the time elapsed from the onset of the output pulse to its end.
• DELAY - defines the time elapsed from the beginning of the input trigger to the
beginning of the output pulse.
• INTER (interval) - defines the time elapsed between the beginning of a pulse and the
beginning of the following pulse. (cycle time = 1/rate).
• M - defines the number of pulses per train in the TRAIN mode.
Figure 1.