Use and Care Manual

7
Using your A-MAZE-N SMOKER TUBE is as easy as 1-2-3! Just Fill, Light, Smoke.
Follow the simple directions below to GET FIRED UP!
1. FILL. Hold the TUBE with the open end facing up and fill 1” from
the top with A-MAZE-N pellets. Other pellets may be used, but
results can vary.
For the EXPANDABLE TUBE-EX, expand or collapse the
TUBE to the desired length before filling.
2. LIGHT. Set your TUBE horizontally on a level surface or grate. With a
propane torch on low, light the pellets through the open end for
45 seconds. A small flame will appear on top of the pellets. Allow
this flame to burn for 10 minutes – DO NOT RUSH THIS STEP.
Optional starting methods:
Use the Gel Alcohol or QuickFire fire starter, both available
on our website!
• Gel Alcohol Fire Starter: Squeeze a liberal amount of gel over the
pellets just inside the open end and light with a standard lighter.
• QuickFire Fire Starter: Place one pouch in the open end of the
Tube Smoker, just under the leading edge of the pellets, leaving
approximately ½ of the pouch exposed. Light the pouch with a
standard lighter, using the edge of the individual packet as a wick.
3. SMOKE. After allowing your pellets to burn for 10 minutes and they are
burning well, softly blow the flame out. Close the lid or door
to your grill or smoker and walk away! Be sure that the TUBE is
placed in an area with good ventilation.
USE CAUTION when handling the TUBE, as the metal can be hot!
For smoke times and pellet/dust usage, see page 8.
6" & 12" TUBE6" & 12" TUBE-EX
6
Using your A-MAZE-N SMOKER MAZE is as easy as 1-2-3! Just Fill, Light, Smoke.
Follow the simple directions below to GET FIRED UP!
Using Pellets vs Dust?
• The 5x8 MAZE can use pellets or dust. The 6x6 MAZE can use dust ONLY.
• Dust is for cold smoking only or for temperatures under 180º F. Using dust at
a higher cook temp may cause it to burn more quickly.
1. FILL. Fill the MAZE with A-MAZE-N pellets or dust. Other pellets or
dust may be used, but results can vary. Be sure to keep the pellets
or dust below the top of the dividers to avoid the burn from
“jumping” rows.
2. LIGHT. Set your MAZE on a level surface or grate. With a propane torch
on low, light the pellets through the starter hole for 45 seconds.
A small flame will appear on top of the pellets. Allow this flame
to burn for 10 minutes – DO NOT RUSH THIS STEP.
Optional starting methods:
Use the Gel Alcohol or QuickFire fire starter, both available
on our website!
• Gel Alcohol Fire Starter: Squeeze a liberal amount of gel over the
pellets near the starter hole and light with a standard lighter.
• QuickFire Fire Starter: Place one pouch in the MAZE near either
starter hole, and under the pellets, leaving approximately ½ of
the pouch exposed. Light the pouch with a standard lighter, using
the edge of the individual packet as a wick.
3. SMOKE. After allowing your pellets to burn for 10 minutes and they are
burning well, softly blow the flame out. Close the lid or door to your
grill or smoker and walk away! Be sure that the MAZE is placed in
an area with good ventilation.
USE CAUTION when handling the MAZE, as the metal can be hot!
For smoke times and pellet/dust usage, see page 8.
5x8
MAZE
6x6
MAZE
Instructions for 6" & 12"
A-MAZE-N
®
SMOKER TUBE
Instructions for 6x6 & 5x8
A-MAZE-N
®
SMOKER MAZE
For suggestions on how to get the most out of your MAZE,
see our Tips & Tricks on page 9 or visit us at www.amazenproducts.com
For suggestions on how to get the most out of your TUBE,
see our Tips & Tricks on page 9 or visit us at www.amazenproducts.com