Specifications

ptg
59
Creating a Sequence
To begin assembling the rough cut of the transformation scene:
1. Open the _Sequences Chap 2 bin in the Chapter 2 folder (within
Chapter Exercise Material).
2. Right-click in the bin, and select Create New Sequence. Name the
sequence Transformation Scene rough cut.
3. Load the Tony interview 1 clip into the Source monitor. If you cre-
ated IN and OUT points for this clip in the previous exercise, they will
already be marked. If not, then mark an IN and an OUT around the
appropriate sound bite listed earlier (“First shot: Tony interview (1)”).
4. Make sure that V1, A1, and A2 are selected in the source Track
Selector panel, and make sure that V1, A1, and A2 are selected in the
record Track Selector panel.
5. Splice this shot into the Timeline by doing one of the following:
 Press the V key to splice the shot into the Timeline.
 Click in the Source monitor, and drag the clips directly to the
Timeline.
6. Repeat steps 3–5 for the rest of the shots (shots 2–5), as listed earlier.
Again, if you created IN/OUT points in the previous exercise, most of
these should already be marked appropriately.
These shots are now in the right order, but the pacing needs a bit of
tweaking. You also have a few verbal stumbles to remove. Don’t worry
about either of these yet; you will fix them at a later stage.
NOTE If you drag the
clip to the Timeline,
selecting the record track
selectors in step 4 is not
actually necessary.
NOTE If you choose to
drag the segments to the
Timeline, be sure to press
and hold Ctrl (Windows)
or Command (Macintosh)
as you drag so that the
clips snap to the appro-
priate edit points.
Download from www.wowebook.com