Troubleshooting guide

Installing Drives 7-5
,QVWDOOLQJD'ULYHLQD  ,QFK 'ULYH%D\
The 5.25-inch drive bays can accommodate any of the following types of half-height
drives:

A diskette drive or tape drive that uses the diskette/tape drive interface on the
system board

A CD-ROM or tape drive that uses the secondary EIDE interface on the system
board

A CD-ROM drive or tape drive that uses its own controller card
NOTE: For information on configuring, connecting, and installing SCSI drives, see
“Installing SCSI Devices” found later in this chapter.
To install a drive in a 5.25-inch bay, follow these steps:
&$87,21*URXQG\RXUVHOIE\WR XFKLQJDQXQSDLQWHGPHWDOVXUIDFHRQW KH
EDFNRI WKHF RPSXWHU
&$87,21:KHQ\RXXQSDFNWKHGULY HGRQRWVHWLWRQDKDUGVX UIDFH
ZKLFKPD\GDPDJHWKHGULYH,QVWHDGVHWWKHGULYHRQDVXUIDFHVXFKDVD
IRDPSDGW KDW Z LOOVXIILFLHQWO\FXVKLRQLW
  8QSDFNW KHGULYHDQGSUHSDUHLWIRULQVWDOODWLRQ
Check the documentation that accompanied the drive to verify that the drive is
configured for your computer system. Change any settings necessary for your
configuration.
NOTE: If you are installing a non-EIDE tape drive, check the documentation for
the drive to determine the jumper or switch settings used to designate the drive
as drive address DS4 (not DS2 or DS3 as may be indicated in the drive documen-
tation). Unless the drive is already set to drive 4, reconfigure its jumper or switch
setting (see “Jumpers” and “Switches” in Chapter 5).
If you are installing an EIDE CD-ROM or EIDE tape drive, configure the drive for
the Cable Select setting.
&$87,216HH´3UR WHFWLQJ$JDLQVW(OHFWURVWDWLF'LVFKDUJHµLQWKHVDIHW\
LQVW UXFWLR QVDW W KHIUR QW R IWKLVJX LGH
 5 HPRYHWKHFR PSXWHUFRYHUDVLQVW UXFWHGLQ´5HPRYLQJWKH&RPSXW HU
&RYHUµLQ&KDSW HU
 5HPRYHWKHGULYHEUDFN HWIURPWKHED\\RXZDQWWRXVH
Squeeze the metal tabs that extend from each side of the drive bracket toward
each other, and pull the bracket out of the bay (see Figure 7-6).
NOTE: For easier access inside the chassis, you may want to rotate the power
supply out of the way temporarily. To do so, see “Rotating the Power Supply
Away From the System Board” in Chapter 5.