A.O. Smith AOW-3000 Owners Manual

NEED HELP? GIVE US A CALL 833.232.9711 NEED HELP? GIVE US A CALL 833.232.9711
ESCUTCHEON
GASKET
1 Select an easily accessible area under
sink to mount System Manifold. Allow
at least a 4-6" clearance to the oor
below lters to allow ample space for
lter changes.
To help gauge the right location for
your System Manifold, insert First and
Third Stage lter sumps into Manifold.
Insert sumps by aligning top connection
points and push up and to the right
until sumps are locked in.
INSTALLATION GUIDE
4 5
Note: Drilling holes into solid surfaces or surfaces made of stone should only
be performed by a qualied and certied installer.
STEP 2 - Install System Manifold
2 Mark wall placement for mounting
screws using the built-in bracket on
back of Manifold. Ensure holes are
as level as possible.
3 Drill two pilot holes for mounting
brackets using 1/8" drill bit for the
System Manifold.
Note: Do not drill into anything
beyond the cabinet wall.
4 Insert anchors and mounting screws into
the wall leaving approximately 3/8" of
each screw exposed.
5 Remove First and Third lter sumps from
Manifold by turning each sump to the
left and pulling down before hanging
Manifold on wall. Mount Manifold on
wall and screw in place.
Note: Avoid over-tightening.
You will need a sink top hole 1 1/4" in diameter for the faucet. If drilling a new
hole, ensure faucet body will mount at against surface and there is sufcient
tubing between faucet body and System Manifold.
STEP 3 - Install RO faucet
1 Place the metal escutcheon
and black gasket on the faucet
base and feed the tubing and
faucet threads through the
countertop hole.
2 Slide the metal washer
onto the faucet.
Thread the faucet
nut onto the faucet
threads. Tighten
by hand.
3 Measure the white 3/8" tubing from the
faucet to the manifold and cut to desired
length. Leftover tubing will connect
Manifold to Tank.
WASHER
FAUCET NUT