Operation Manual

Installation

30 Instruction manual ADMR

3.10.2 Preparation

Caution

The appliance is phase-sensitive. It is absolutely essential to connect the

mains phase (L) to the phase of the appliance, and the mains neutral (N) to the

neutral of the appliance.

Caution

There may be no potential difference between neutral (N) and earth ( ).

If this is the case, then an isolating transformer must be applied in the supply

circuit (3.10.5 "Connecting an isolating transformer").

For more information or to order this isolating transformer, please contact

A.O. Smith Water Products Company.

The figure shows a view of the terminal blocks, and the table explains the

relevant connections.

Terminal blocks

In preparation you must first remove the protective cover from the control

1. Undo the 4 screws (A) and remove the protective cover (B) from the

electrical section. The terminal blocks (C) will now be visible.

Consult the Electrical Diagrams ADMR for the electrical component

connections.

Legend

A. screws

B. protective cap

C. connector block

IMD-0125 R2